View source for Protocol for saltwater stable isotope analysis on Picarro

'''Liquid run setup salt water'''

'''1. Prepare standards'''
- Use BERM for drift

- DI2 and EVAP2 for sample calibration

- Prepare once in inset vials before a set of runs

'''2. Run setup'''

- Order DI2, BERM, EVAP2

- Blocks of 8 samples

- BERM drift standard

- Repeat 3x for total 24 samples, with 2 drift samples in between, takes up 29 spots

- Rinse syringe with extra sample in position #43, after 10 samples

'''3. Select method'''

- Single wet peak, requires 2 extra injections, peak goes to waste (salt)

- FARLAB_Rinse_2, strokes, small injection

'''4. Number of Injections'''

- Standards: 14 injections (12 in data file)

- Samples: 8 injections (6 in data file)

'''5. Rinsing method'''

- 5 injections, results in one small injection of rinse sample due to single wet peak routine

'''6. Equipment cleaning'''

- Salt mesh exchanged after 24 samples, clean in ultrasonic bath, dry in glass oven, keep with septa

- Septum washed after each run, exchanged if needed after inspection

- Syringe washing in DI before and after run, repeated strokes until flow is smooth, moving plunger up and down over whole volume